Small Business Information

Setting Up a Pressure Washer Rig to Clean Concrete


Maximum efficiency in the cleaning industry is a key to survival and higher rates of income. The trailer or tuck unit needs to be set up so that you can use a garden hose and external water supply, because you never know when you are going to need one for concrete or other types of jobs. Any new rig should also come with quick releases between the tank and the intake tube to the pressure washer. There should also be a valve that is turned so the water is running from the black tank that now holds the external water that comes in if you are running thru an unmodified hot water pressure washer skid unit with a float tank.

There needs to be a connection for a water hose that is on top of the black small tank. The inside of the tank has a floater in it so water will not run over when you are not depressing the trigger and letting out water. When cleaning concrete always use 3000+ PSI and 180+ degree water. These two elements are key to cleaning concrete effectively and correctly.

Now let's talk about chemicals for a minute. To clean rust there is a product made by Simonize that can be ordered from Howard at AAA Pressure Washers in Arizona that is called "Concrete Cleaner and Etch". Delco Cleaning Systems in Texas has another chemical that works quite well; www.DCS1.com . This chemical is an acid and can be very dangerous, but they sure work well. To apply this chemical you can spray it with a metal hand held spray canister. If you use a sprayer that has plastic parts to it, the sprayer won't last more then a one or two times before the parts melt and it is useless. The chemical should be mixed 50-50 with water. If you are using it on colored concrete try a test patch first because this stuff bleaches and lightens so it might make it lighter than the original concrete.

For removing oil or grease stains Simonize SC-260 can be used. It is a granule type chemical that looks like kitty litter. To apply it you need to wet down the area to be treated first then spread a thin layer of it over the spot. Take a brush and agitate it to work it in. Let it set about fifteen to twenty minutes before removing it. Make sure you are very through in removing the granules. This next chemical should be used for emergencies if at all possible. This stuff is very thick and should be applied with a roller brush that is an adhesive type roller. Let it set for fifteen to twenty minutes and then remove it being very careful not to get it on you or any of the other chemicals for that matter.

To develop the most efficient use of time at a concrete job site one person should be sweeping up loose debris from the work area while the other is setting up the equipment. Be sure all the corners are swept well because this is the area where most lose dirt seems to end up. Remember that when you hydro twist an area that you are simply lifting the dirt and stains. You need to go back over the areas afterwards to move the dirt away from the concrete. After you have used the hydro twister on the area you then need to cover all siding up with your cover plate or what ever guard you find works best and proceed to hand wand any trouble spots and the outer edges of the concrete.

Finally, when working where a lot of contractors are working be sure to be polite and try to work around them. You never know who they have contacts with. They may refer you to some one else. Concrete is a great "filler" account if it happens to be raining and you have been specializing in other types of pressure washing like truck washing. You can always do concrete in any type of weather and it pays very well for what you to do for the job. So remember, concrete work is always good to have. I hope this helps you in your pressure washer business.

"Lance Winslow" - If you have innovative thoughts and unique perspectives, come think with Lance; www.WorldThinkTank.net/wttbbs


MORE RESOURCES:
Unable to open RSS Feed $XMLfilename with error HTTP ERROR: 404, exiting
home | site map | contact us